Advertisement
Step 1: Insert 2 fresh AA, LR6 1.5 volt batteries into the TX29U-IT
sensor. Observe correct polarity.
Step 2: Insert 2 fresh AA, LR6 1.5 volt Alkaline batteries into the
wireless forecast station. Observe correct polarity.
Step 3: After 5 minutes place sensor outside in a shaded location.
Restart: If the outdoor temperature shows dashes, remove batteries
from the station & outdoor sensor. Press any button on the station 20
times. After 15 minutes, return to Step 1.
Set Time, Date, Temperature Units, Forecast Sensitivity
1. Hold the SET button to enter time set mode.
2. To adjust values press the IN button.
Note: When setting time, the IN button will set the hour and the OUT
button will set the minutes. When setting the calendar, the IN button
will set the month and the OUT button will set the date. Exception: if
you select 24 hour time format the IN button will set the date and the
OUT button will set the month.
3. Press the SET button to confirm adjustments and move to the next
item.
Settings order:
1. Contrast (lcd 3)
2. Time Zone (0 to +/- 12)
3. Daylight Saving Indicator
(DST1 = ON or DST0 = OFF)
4. Radio-controlled Time Signal (RCC ON/OFF)
5. 12/24 Hour Time Format (12h or 24h)
6. Time (hour and minutes flash together)
7. Year (2012)
8. Month/Date
(1.1 month and date flash together)
9. Snooze Time (10) not an active feature
10. Fahrenheit/Celsius (ºF/ºC)
11. Forecast Sensitivity (2 and forecast icon flashes)
Note: The lowest number is used near the coastline, The highest
number is for the desert, and middle number (default) is for
everywhere else.
Press the SET button to exit, or wait 15 seconds without pressing
buttons to return to the normal time display. Press the CH button at any
time to exit the settings menu.
WS-7014CH-IT
Get Started
www.lacrossetechnology.com/support
SET
IN
Page | 2
OUT
Advertisement
