Installation; Appropriate Installation Location; Removing Packaging Reinforcement; Removing The Transportation Locks - Beko WMB 81241 M Lavatrice User Manual

3

Installation

Refer to the nearest Authorised Service
Agent for installation of the product. To
make the product ready for use, review the
information in the user manual and make
sure that the electricity, tap water supply
and water drainage systems are appropriate
before calling the Authorized Service Agent.
If they are not, call a qualified technician
and plumber to have any necessary
arrangements carried out.
C Preparation of the location and
electrical, tap water and waste water
installations at the place of installation is
under customer's responsibility.
B
Installation and electrical connections of
the product must be carried out by the
Authorized Service Agent. Manufacturer
shall not be held liable for damages that
may arise from procedures carried out
by unauthorized persons.
A Prior to installation, visually check if the
product has any defects on it. If so, do
not have it installed. Damaged products
cause risks for your safety.
C Make sure that the water inlet and
discharge hoses as well as the power
cable are not folded, pinched or
crushed while pushing the product into
its place after installation or cleaning
procedures.

Appropriate installation location

• Place the machine on a rigid floor. Do
not place it on a long pile rug or similar
surfaces.
• Total weight of the washing machine
and the dryer -with full load- when they
are placed on top of each other reaches
to approx. 180 kilograms. Place the
product on a solid and flat floor that has
sufficient load carrying capacity!
• Do not place the product on the power
cable.
• Do not install the product at places
where temperature may fall below 0ºC.
• Place the product at least 1 cm away
from the edges of other furniture.
Removing packaging
reinforcement
Tilt the machine backwards to remove
the packaging reinforcement. Remove the
packaging reinforcement by pulling the
ribbon.
Removing the
transportation locks
A Do not remove the transportation
locks before taking out the packaging
reinforcement.
A Remove the transportation safety bolts
before operating the washing machine,
otherwise, the product will be damaged.
1. Loosen all the bolts with a spanner until
they rotate freely (C).
2. Remove transportation safety bolts by
turning them gently.
3. Attach the plastic covers supplied in the
User Manual bag into the holes on the
rear panel. (P)
40
EN