Advertisement

Quick Links

Installation Instructions
& User Manual
for the super-efficient
Wood Burning Stoves
Models
9307
Wood Burning Stove
Applicable Appliance: Carlby 9307
Document reference BUR/04/16
Revision date: April 2016
THESE INSTRUCTIONS MUST BE LEFT WITH THE USER
FOR FUTURE REFERENCE
Page 1 of 20

Advertisement

Table of Contents
loading

Summary of Contents for Burley 9307 Fireball

  • Page 1 Installation Instructions & User Manual for the super-efficient Wood Burning Stoves Models 9307 Wood Burning Stove Applicable Appliance: Carlby 9307 Document reference BUR/04/16 Revision date: April 2016 THESE INSTRUCTIONS MUST BE LEFT WITH THE USER FOR FUTURE REFERENCE Page 1 of 20...
  • Page 2: Table Of Contents

    Table of Contents Approvals ............................4 TECHNICAL DATA ......................... 5 Stove Dimensions .......................... 6 Installation Instructions......................... 7 The Clean Air Act 1993 and Smoke Control Areas ..............7 Chimneys, Flues, Hearths and Surrounds ................... 8 Air Supply and Room Sealing Kit ....................10 Door Handle Assembly ........................
  • Page 3 Thank You Thank you for purchasing a Burley Fireball Wood Burning Stove; we hope you will be delighted with the super-efficient performance. Picture is for illustrative purposes only Included with your stove is the Burley ‘Thank You Kit’*, which typically contains:- ·...
  • Page 4: Approvals

    Features… Cross Section – Artist Impression Approvals All our wood stoves are approved to EN13240:2001 and EN13240 A2:2004. Page 4 of 20...
  • Page 5: Technical Data

    TECHNICAL DATA Carlby All built to EN13240 9307 80.2% Efficiency (Net) CO concentration 0.11% @ 13% Oxygen Dry logs <20% H₂O Requirement of fuels used in smoke control Maximum length 250 – 300mm long areas Maximum width 150mm Dry Logs Lower quality fuel can be used in non-smoke <...
  • Page 6: Stove Dimensions

    Stove Dimensions Carlby 9307 Page 6 of 20...
  • Page 7: Installation Instructions

    Installation Instructions When installing these appliances, all local regulations including those referring to national and European Standards need to be complied with. This manual covers the appliances: Burley Model: 9037 Stove The nominal space heating output is: ‘Carlby’ 9307: 7Kw The above appliance should be installed by an installer registered with a competency scheme (i.e.
  • Page 8: Chimneys, Flues, Hearths And Surrounds

    Aeration hole must be left open for Aeration hole can be use in smokeless closed, if not used in areas. smokeless areas. Chimneys, Flues, Hearths and Surrounds Chimneys The 9037 requires a minimum chimney flue of 6” (150mm). All chimneys/flues must be a minimum length of 4 metres and must comply with Building Regulations J.
  • Page 9 Stoves are very heavy and most materials used for hearths crack very easily. It is impossible for Burley to inspect each hearth or comment on every installation, so the onus is on the installer to ensure the construction of the hearth is suitable for the application.
  • Page 10: Air Supply And Room Sealing Kit

    Regulations Part J and should be sited where they cannot be blocked. WARNING The Burley Fireball series of stoves are primarily for burning wood (this includes logs and sawdust briquettes). In smoke control areas only wood fuels should be used.
  • Page 11: Door Handle Assembly

    Door Handle Assembly Door Handle Adjustment There is a CAM and LOBE mechanism which allows the handle to be moved up and down or in and out. If required, adjust the handle so it lines up and engages correctly with the stud in the side of the stove.
  • Page 12: Assembly And Installation Of The Stove Fire Bricks And Baffle

    Assembly and Installation of the Stove Fire Bricks and Baffle Having positioned your Burley stove and connected it to a chimney with flue pipe, you need to assemble the inside parts. There are four internal components: top brick, two side cheeks, and a rear brick.
  • Page 13: Commissioning The Appliance

    Commissioning the Appliance On completion of the installation, when any fire cement or paint used has dried, a smoke ‘bomb’ should be burnt and all joints checked for smoke leakage and the chimney draw checked with all doors and windows closed. Please leave the instructions with the customer and inform them;- The first time the stove is lit only a small fire should be used to allow the paint to cure properly.
  • Page 14: Using The Moisture Meter

    Do not over load the stove with wood and close the damper down, this produces lots of creosote and blackens the glass Using the Moisture Meter For the stove to operate at maximum efficiency the wood should be as dry as possible, certainly below 18%.
  • Page 15: Stove Thermometers - Do Not Use With Our Stoves

    Stove Thermometers - DO NOT USE WITH OUR STOVES We receive a very small number of calls from customers who have managed to damage their stoves from over-firing, in almost all cases they have a thermometer fitted to their flue. The Fireballs are the world’s most efficient stove because firstly, due to the unique method of introducing air, the combustion chamber is extremely hot, and secondly, the heat is extracted from the combusted gasses to heat the room before it enters the flue.
  • Page 16: Troubleshooting/Poor Appliance Operation

    Troubleshooting/Poor Appliance Operation Refuelling onto a low If there is insufficient burning material in the firebed to light a new fire bed fuel charge, excessive smoke emission can occur. Refuelling must be carried out onto a sufficient quantity of glowing embers and ash that the new fuel charge will ignite in a reasonable period.
  • Page 17: Reasons For Premature Wear Of Internal Parts

    · The chimney can be swept through the stove. · Unless advised by Burley the stove should not be used with any baffle missing. · All rope and glass seals should be checked annually and replaced as necessary.
  • Page 18: Safety

    HETAS installer, who will be able to provide the answers to most questions. Your Burley retailer also has a great deal of experience and will also be able to provide helpful advice. Further help is available from Burley’s Customer Services department who will be pleased to give advice, if necessary.
  • Page 19: Spare Parts

    Spare Parts 9307 - Carlby DESCRIPTION PART NO TOP VERMICULITE BOARD WTOPBAFFLE5 BACK VERMICULITE BOARD WBACLINER9307 BOTTOM VERMICULITE BOARD WBOTLINER5 LEFT HAND VERMICULITE BOARD WL/HLINER9307 RIGHT HAND VERMICULITE BOARD WR/HLINER9307 GLASS WGLA9307 HALF GLASS WGLAS9307H GLASS ROPE TAPE WROPE DOOR SEAL ROPE WSEALROPE STAINLESS STEEL BAFFLE WLOWBAFSMA...
  • Page 20: Customer & Installation Notes

    Customer & Installation Notes Date of Installation: Installer Name & contact details Chimney Swept Date Notes: Made in the UK Burley Appliances Limited Further information can be found at: Lands’ End Way http://burley.co.uk/category/wood- Oakham burning-stoves/ Rutland Email: sales@burley.co.uk LE15 6RB...

Table of Contents