Outgoing Announcements - AT&T E5909B User Manual

16
Elapsed
Press to stop
recording time
recording.
(seconds).
1.
ANNC
"Announcement.
Press PLAY or press
RECORD."
2.
(Play/
Stop
(Plays announcement
previously recorded).
- OR -
3.
RECORD
"Record after the tone.
Press STOP when you
are done."
Speak into microphone.
4.
Microphone
5.
(Play/
Stop
(Announcement is
played back).
6.
ANNC
to exit announcement programming.
Answering System Operation

Outgoing announcements

Outgoing announcements are the messages callers hear
when calls are answered by the answering system.
The phone is pre-programmed with an announcement.
If the phone is set up to record messages, the phone
answers calls with "Hello. Please leave a message
after the tone." You can use this announcement, or
replace it with a recording of your own voice.
NOTE: Press ANNC to exit the announcement programming.
To play your outgoing announcement
)
Press
ANNC
PLAY or press RECORD." Then press
will hear the outgoing announcement.
To record your outgoing announcement
Press
ANNC
PLAY or press RECORD." Then press
and begin speaking after you hear "Record after the
tone. Press STOP when you are done." Speak fac-
ing the telephone base from about nine inches away.
Press
PLAY
announcement will be played back.
Elapsed time (in seconds) will be shown in the message
window as you record. You can record an announce-
ment up to 90 seconds long. Announcements less than
three seconds long will not be recorded.
To delete your outgoing announcement
)
Press
ANNC
PLAY or press RECORD." Then press
begin playback. Press
your announcement.
When your announcement is deleted, calls will be
answered with the pre-programmed announcement
described above.
until you hear "Announcement. Press
until you hear "Announcement. Press
when you are done. Your recorded
/STOP
until you hear "Announcement. Press
during playback to delete
DELETE
38 38
. You
PLAY/STOP
RECORD
to
PLAY/
STOP