Connecting Hoses - LG WT1485CW Owner's Manual

C
onnecting Hoses
Water Supply Hose
1 Connect the water supply hose to the tap.
Push the water supply hose up so that the sealing
washer within the hose can adhere completely to
the tap.
Tighten it by turning to the right.
2
Connect water supply hose to the machine.
Verify there is a sealing washer
inside the connector.
Connect the water supply hose to inlet valve of
the washing machine, and then lock it by turning
the hose connecting part.
3
Check water leakage.
After connecting the hose, open the tap
to check for any water leakage.
Drain Hose
1
Fit the end of the drain hose to the outlet of the
drain pump of washer and tighten the clamp.
2
Put the other end of the drain hose
over the standpipe or wash tub.
To prevent accidental dislodging
secure the drain hose to the standpipe,
inlet hose or laundry tub with the tie
strap provided in the parts package.
Note
• To prevent siphoning, the drain hose should not be extended more than 2" from the end of the hose guide.
• The discharge height should be approximately 36 ~ 47" from the floor.
Water
Tap
Sealing Washer
Water Supply Hose
Hose Connector
Inlet
Valve
within 2"
Hose
Guide
36~47"
Tie Strap
Sealing Washer
Drain Hose
21