Chevrolet Volt 2016 Owner's Manual page 35

34 Keys, Doors, and Windows
When all additional transmitters
are programmed, press and
hold POWER for 12 seconds
to exit programming mode.
8. Return the key back into the
transmitter.
Starting the Vehicle with a Low
Transmitter Battery
If the transmitter battery is weak or
there is an interference with the
signal, the DIC may display NO
REMOTE DETECTED or NO
REMOTE KEY WAS DETECTED
PLACE KEY IN TRANSMITTER
POCKET THEN START YOUR
VEHICLE when you try to start the
vehicle. The REPLACE BATTERY
IN REMOTE KEY message may
also be displayed at this time.
To start the vehicle:
1. Open the center console
storage area and remove the
rubber mat.
2. Place the RKE transmitter into
the transmitter pocket.
3. With the vehicle in P (Park) or
N (Neutral), press the brake
pedal and POWER
center stack. See Power
Button 0 172.
Replace the transmitter battery as
soon as possible.
Battery Replacement
When replacing the battery, do
not touch any of the circuitry on
the transmitter. Static from your
body could damage the
transmitter.
on the
1. Press the button on the side of
the transmitter near the bottom
and pull the key out.
Caution