Chevrolet Volt 2016 Owner's Manual page 302

Hide thumbs Also See for Volt 2016:
Table of Contents

Advertisement

2. Park both vehicles close
enough so that the jumper
cables can reach both vehicles'
positive (+) and negative ( )
terminals. The vehicles must
not touch each other. It could
cause an unwanted ground
connection that could damage
both vehicles' electrical
systems.
Put both vehicles in P (Park)
for an automatic transmission
or electric drive unit. For a
manual transmission, place the
vehicle in Neutral and set the
parking brake.
Caution
If any accessories are left on or
plugged in during the jump
starting procedure, they could be
damaged. The repairs would not
be covered by the vehicle
warranty. Whenever possible, turn
off or unplug all accessories on
either vehicle when jump starting.
3. Turn off both vehicles. Turn off
the radio, all lamps, and
accessories that are not
needed in both vehicles.
Unplug accessories from the
cigarette lighter or the
accessory power outlets. This
avoids sparks and helps save
both batteries and accessories.
4. Locate the positive (+) and
negative ( ) terminals on the
vehicle with the run-down
battery.
5. Locate the positive (+) and
negative ( ) battery terminals
on the Volt. The 12-volt battery
is under the load floor in the
rear cargo area. Open the
access covers for the
positive (+) terminal (1) and the
negative ( ) terminal (2).
6. Check that the jumper cables
do not have loose or missing
insulation or a shock could
result and the vehicles could
be damaged.
Before connecting the jumper
cables, here are some basic
things to know. Positive (+)
Vehicle Care
jumper cable goes to
positive (+) battery terminal or
a remote positive (+) terminal if
available. Negative ( ) jumper
cable goes to remote
negative ( ) terminal if
available, or a heavy,
unpainted metal engine part or
a solid engine ground on the
vehicle with the run-down
battery.
Do not connect positive (+) to
negative ( ) or there will be a
short that may damage the
battery or other parts of the
vehicle. Do not connect the
negative ( ) cable to the
negative ( ) terminal on the
run-down battery because this
can cause sparks.
Caution
If the jumper cables are
connected or removed in the
wrong order, electrical shorting
may occur and damage the
vehicle. The repairs would not be
(Continued)
301

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Volt 2017

Table of Contents