Makita BTW072 Instruction Manual page 6

The remaining Battery capacity
(C) E
E
001258
Auto-stop mechanism
The tool stops automatically after the battery capacity
reaches under 20% to prevent the lack of fastening
torque. (Red color lamp lights on.) Charge the battery
cartridge or use a new fully charged one.
Auto-Stop setting for number of impacts
This tool has a convenient auto-stop mechanism that
allows you to preset the desired number of impacts in
terms of the application.
automatically after reaching the preset number of
impacts.
1. Pulling the switch trigger, insert the battery
cartridge. Keep on pulling the switch trigger after
inserting the battery cartridge. (The indicating
lamp on the back of the tool will flash about 10
times, then the lamp will keep lighting up lit.)
ON
2
3
001259
2. Hit the tool housing around the grip once with a
screwdriver etc. (The indicating lamp will go out.)
1
2
001260
3. Release the switch trigger. (The indicating lamp
will keep lighting up lit for 0.5 seconds, then the
lamp will go out.)
F
F
The tool then
1. Indicating lamp
1
2. Switch trigger
3. Battery cartridge
1. Tool housing
2. Screwdriver
OFF
001261
4. Hit the tool housing preset number of first digit
except 0. (The indicating lamp will light up in green
color. Then, the light goes out.)
Example:
•
5. Pull the switch trigger, then release it.
6. Hit the tool housing preset number of second digit
except 0. (The indicating lamp will light up in red
stops
color. Then, the light goes out.)
Example:
•
7. Pull the switch trigger, then release the switch
trigger. (The indicating lamp will light up.)
8. Remove the battery cartridge. (Presetting has
finished.) (The indicating lamp will go out.)
CAUTION:
When you change the presetting, do the same
•
procedure as above 1 - 8.
Confirming the presetting
Switch off the tool and insert the battery cartridge. The
indicating lamp will indicate the presetting number.
Green lamp shows the first digit. Red lamp shows the
second digit.
Example:
•
1. Green color lamp flashes once.
2. Red color lamp flashes twice.
3. The lamp goes out.
6
When the preset number is 12, hit the
tool housing once.
When the preset number is 12, hit the
tool housing twice.
presetting number is 12.