Advertisement
Installing the Si 4000 Modem
Specifications
Physical and electrical:
•
Power Consumption: 12W maximum
Power adapter: Input of
•
100 VAC - 240 VAC 50 Hz to 60 Hz
Connectors:
•
Ethernet: 10/100Base-T (RJ-45)
•
VoIP: RJ-11 telephone port
•
Standard DC power jack
FCC Radio Frequency Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC and EN300385 Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications.
FCC Radiation Hazard Warning
To comply with FCC RF exposure requirements in Section 1.1307and 2.1091 of FCC Rules,
the antenna used for this transmitter must be kept at a separation distance of at least 20 cm
from all persons and must not be co-located or operating in conjunction with any other
antenna or transmitter.
Electronic Emission Notice
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
R&TTE Compliance Statement
This equipment complies with the appropriate essential requirements of Article 3 of the
R&TTE Directive 1999/5/EC.
P/N 215629
Environmental:
•
Operating temperature: 0°C to 40°C
•
Operating humidity: 5%-95%
Standard compliance:
2.5 GHz models:
•
UL 60950-1
•
IEC 60950-1
•
FCC Part 15, 27
•
ETSI EN 302 544
•
ETSI EN 301 489
•
ETSI EN 302 326
•
ETSI 300 328
-7-
3.5 GHz models:
•
ETSI EN 301 489
•
ETSI EN 302 326
•
ETSI 300 328
February 2010
Advertisement
