Getting Started - Technika KR07 User Manual

GETTING STARTED

HANDSET PREPARATION
Remove the protective strip from the battery compartment to activate
the battery. The handset is now ready for use.
If the handset behaves erratically or fails to
operate the battery should be replaced.
1: Press the catch at the side of the battery
compartment. Slide out the battery cage
2: Remove the old battery. Place the new bat-
tery in the cage with the polarity as shown.
Close the cage.
There is a risk of fire and burns if the battery
is handled improperly. Do not disassemble,
crush, puncture, short external contacts, or
dispose of in fire or water.
Do not attempt to open or service the battery. Replace only with the
battery designated for this product. Discard used batteries in accord-
ance with recycling regulations in force in your area.
PLACEMENT
Screw the stand into the threaded insert at the rear right of the DPF.
Do NOT overtighten.
Switch the ON /OFF switch on the frame to OFF.
Stand the frame on a level solid surface where it is unlikely to fall or
get knocked over.
The frame can be wall mounted via the slots in the rear but this is not
recommended. Wall mounting should only be used as a last resort.
Page 7