Laser component in this product is capable
of emitting radiation exceeding the limit for
Class 1.
This appliance is classified as a CLASS 1 LASER product. The
CLASS 1 LASER PRODUCT MARKING is located on the rear
exterior.
The following caution label is located inside the unit.
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous radiation
exposure.
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be
damaged by heat.
Flexible Circuit Board Repairing
• Keep the temperature of soldering iron around 270˚C
during repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
MODEL IDENTIFICATION
- BACK PANEL -
4-228-930-1
4-228-930-2
4-228-930-3
Parts No.
: AEP, UK model
: US model
: Canadian model
TABLE OF CONTENTS
·························································· 6
········································································ 12
3-1. Case ·················································································· 16
3-9. BD Board ·········································································· 20
···································································· 22
Main Section ····································································· 37
6-8. Printed Wiring Board
6-10. Printed Wiring Board
6-13. Schematic Diagram
6-15. Schematic Diagram
6-16. Schematic Diagram
6-17. Printed Wiring Board
6-19. Printed Wiring Board
6-20. Printed Wiring Board
6-21. Schematic Diagram
PANEL Section ···························· 57
6-22. Printed Wiring Board
6-23. Schematic Diagram
······························· 27
AD Section ································ 44
DIO Section ······························ 46
PANEL Section ························· 56
······································· 79
3