Sony MDS-JA333ES Service Manual page 25

4-5-2. Operating the Continuos Recording Mode (Use this mode for self record/playback check only)
1. Entering the continuos recording mode
1) Load the recordable disc to the unit.
The disc is loaded by pushing the tray.
2) Rotate the lAMSL knob to display "CREC 1MODE" (C35).
3) Press the YES button to change the display to "CREC1MID".
4) When access completes, the display changes the display to "CREC1(
Note : The value of the " " displayed on the screen indicates the address of the recorded position.
2. Changing the parts to be recorded
1) Press the YES button during continuos playback to change the display as shown and move the played back part.
during moving.
"CREC1MID" → "CREC1OUT" → "CREC1IN"
2) When access completes, the display changes to "CREC1(
Note : The value of the " " displayed on the screen indicates the address of the recorded position.
3. Ending the continuos recording mode
1) Press the MENU/NO button. The display changes to "CREC 1MODE" (C35) and
2) To eject the disc, press the A button.
Note 1: The playback start addresses for IN, MID, and OUT are as follows.
N : 40h cluster
MID : 300h cluster
OUT : 700h cluster
Note 2: The MENU/NO button can be used to stop recording anytime.
Note 3: Do not perform continuos recording for long periods of time above 5 minutes.
Note 4: During continuos recording, be careful not to apply vibration.
4-5-3. No-Volatile Memory Mode (EEP MODE)
This mode reads and writes the contents of the non-volatile memory.
It is not used in servicing. If selecting this mode accidentally, press the MENU/NO button immediately to exit it.
4-6. Functions of Other Buttons
Function name Main contents
N Sets continuos playback when pressed in the STOP state. When pressed during continuos playback, the
tracking servo turns ON/OFF.
x
Stops continuos playback and continuous recording
M
The sled moves to the outer circumference only when this is pressed
m
The sled moves to the inner circumstance only when this is pressed
REC MODE
Switches between the pit and groove modes when pressed
(other models/SF EDIT/SCROLL)
Switches the spindle servo mode (CLV S ↔ CLV A)
PLAY MODE
DISPLAY/CHAR Switches the display when pressed
A/OPEN/CLOSE Removes the disc
REPEAT/POWER Exits test mode
REC
" and illuminates.
" and REC disappears.
REC
disappears.
REC disappears
25