Brake System; Brake Fluid - BMW 2006 Z4 3.0i2006 Z4 3.0si Owner's Manual

pressure to escape, then continue turning
to open.
3. The coolant level is correct if the upper end
of the red float spindle is at least at the same
level as the upper edge of the filler neck but
no more than 3/4 in or 2 cm above it, i.e. up
to the mark on the float spindle. Refer also
to the diagram next to the filler neck.
4. If the coolant is low, slowly add coolant up to
the specified level; do not overfill.
5. Twist the cap back on and tighten it firmly.
6. Have the cause for the coolant loss
removed as soon as possible.

Brake system

Malfunction

Brake fluid

The warning lamp lights up although
the parking brake is not engaged:
Stop the vehicle immediately.
The brake fluid level in the reservoir is too low.
At the same time, you may notice that brake
pedal travel is longer. Have the system checked
as soon as possible.
If you continue driving, extended brake
pedal travel may be necessary and brak-
ing distances may be significantly longer. Be
sure to adapt your driving style
Canadian models display this warning
lamp.
90
Online Edition for Part-No. 01 41 0 012 083 - © 04/06 BMW AG
Brake pads
replaced as soon as possible.
cific vehicle model. BMW cannot evaluate non-
approved brake pads to determine if they are
suitable for use, and therefore cannot guaran-
tee the operating safety of the vehicle in the
event of their
accordingly.<
The warning lamp lights up. The brake
pads have worn down to the minimum
safe limit. Have the brake pads
For your own safety: only use brake pads
which BMW has approved for your spe-
use.<