NetworX NX-148E User Manual

Quick Reference Guide GE LCD Keypad
Arming To Leave Premises:
1. Verify all protected areas are secure.
2. The keypad must display "System Ready" and / or the ready green light should be on.
3. Press the "Exit" Button on the keypad.
4. The keypad should now display "System Armed – All Zones Secure".
5. Your system is now armed and ready for you to leave the premises. Most systems
have a 60 second exit delay.
Disarming The System:
1. When re-entering the premises, you should hear a steady tone coming from the
keypad. Enter your 4-digit code. The red armed light will go out; your system is now
disarmed. Most systems are programmed with a 30 second entry delay.
2. If the wrong code is entered by accident, press the # key and enter the correct 4-digit
code.
Arming to Stay Inside The Premises:
1. Verify all protected areas are secure.
2. The keypad must read "System Ready" and / or the ready green light should be on.
3. Press the "Stay´ button on the keypad.
4. The keypad should now display "System Armed – Zones Bypassed". Any interior
protection zones programmed to be bypassed "such as motion detectors" are now
bypassed.
5. Press the "Stay" button a second time and this will remove the 30 second delay and
make the system alarm instantly upon any entry.