Pizza Oven Workstation FOR 6000 SERIES for use with Leg Kit PORTABLE OVENS OWNER’S MANUAL IMPORTANT: This instruction manual contains important information necessary for the proper assembly and safe use of the appliance. Read and follow all warnings and instructions before assembling and using the appliance. Keep this manual for future reference.
TABLE OF CONTENTS Warranty and Registration ......2 Assembly Instructions ....... 3 Care and Maintenance ........ 9 CALIFORNIA PROPOSITION 65 WARNING: The burning of gas cooking fuel generates some by-products, which are on the list of substances known by the State of California to cause cancer, reproductive harm, or other birth defects. This product may contain chemicals known to the State of California to cause cancer, reproductive harm, or birth defects.
If any part is missing or damaged, do not attempt to assemble the product. Call customer service at 800- 521-0505. To watch assembly video, go to: www.pizzacraft.com/manuals-use-care/ Estimated assembly time: 20 minutes Tools Required: #2 Phillips screwdriver, 10mm wrench, 5mm hex wrench and rubber mallet/wood block.
Page 4
Remove hood and stones. Then disconnect hose from propane tank and carefully set tank aside. Unscrew the 2 hex screws that secure the legs to the body on the gas hose side of the oven. Then CAREFULLY flip your oven over.
Page 5
Remove the legs from the oven body on the gas hose side. Then align the U-channel end tubes with the legs on the side of the gas hose, making sure the tab on the U-channel end tube is facing away from the oven body, as shown below.
Page 6
Detach the lower half of the legs on the side of the gas hose and slide the wire shelf end tubes over them, making sure the wire shelf is in the proper orientation. Replace the lower half of the leg kit legs and secure wire shelf to exterior leg tabs with M6x8 phillips head screws.
Page 7
Attach interior and rear support bars. Align holes in tabs on wire shelf and U-channel with holes in interior support bar and use M6 carriage nuts and M6x12 carriage bolts to attach interior support bar. Then align holes in rear exterior leg and rear middle leg with rear support bar holes and secure with M5x15 screws.
Page 8
Attach Bamboo Tabletop. Align pilot holes in bottom of tabletop surface with tabs welded to the interior side of the U-channel and secure with M4x14 pan head wood screws. Make sure to attach Gas Hose Bracket to the rear-most M4x14 pan head wood screw and capture hose in its proper configuration, as shown below.
Now you are ready to use your Pizza Oven Workstation. Enjoy! CARE AND MAINTENANCE CLEANING STORAGE Coated Steel Finish Storing your Pizza Oven Workstation To clean, wipe the outside surfaces with a cloth damp- To maximize the lifespan of your Pizza Oven Work- ened with water and a mild dish washing detergent;...
Page 10
ACCESSORIES For these and more visit pizzacraft.com/accessories.html DESCRIPTION ITEM NUMBER ACCESSORY 1 Pound Disposable Tank Adapter: Allows small portable propane bottle to be PC6013 used with the pizza oven. Great for tailgating and camping. Tee Valve: Allows you to use only one or two PC6014 cooking units for a 20 lb.
Page 11
DESCRIPTION ITEM NUMBER ACCESSORY Stone Brush: Long handle brush with natural PC0218 fiber bristles. Keeps stone clean between pizzas. Flexible Dough Rolling Mat: Easy to PC0408 measure and roll perfectly sized pizza crust. Pizza Warming Stand and Tray: 12 inch PC6020 pan is held above the hot oven, keeping the cooked pizza warm.
Need help?
Do you have a question about the 6000 SERIES and is the answer not in the manual?
Questions and answers