Craftsman 315.114260 Operator's Manual page 14

When making a cut use steady, even pressure.
Never force cuts.
Do not cut warped or wet lumber.
Always hold your saw firmly with both hands and keep
your body in a balanced position so as to resist the
forces of kickback should it occur.
When using your saw, always stay alert and exercise
control. Do not remove your saw from workpiece
while the blade is moving.
DEPTH OF CUT ADJUSTMENT
Always keep correct blade depth setting. The correct
blade depth setting for all cuts should not exceed 1/4 inch
below the material to be cut. More blade depth will
increase the chance of kickback and cause the cut to be
rough. One blade tooth below the material to be cut works
best for most efficient cutting action.
TO ADJUST BLADE DEPTH
Remove battery pack from saw.
WARNING:
Failure to remove battery pack from
saw could result in accidental starting causing
possible serious personal injury.
TO RAISE
SAW
TO
LOWER SAW
TO
LOOSEN
Loosen depth adjustment knob. See Figure 12.
Hold base flat against the workpiece and raise or lower
saw until the required depth is reached.
Tighten depth adjustment knob securely.
OPERATION
BASE
ASSEMBLY
TO
TIGHTEN
DEPTH
ADJUSTMENT
KNOB Fig. 12
STARTING A CUT
Know the right way to use your saw.
See Figure 13.
Never use your saw as shown in figure 14.
Never place your hand on the workpiece behind your
saw while making a cut.
WARNING:
always maintain proper control of your saw. Loss of
control of your saw could cause an accident resulting
in possible serious injury.
14
WRONG
To make sawing easier and safer,
Fig. 13
Fig. 14