Kia quoris Manual page 370

5.Lift the end of strip (5) up.
6.Press the fastener head with screw
driver and then pull the fastener
out.
7.Lift the rear portion of small service
cover (6) up and then remove the
service cover.
OKH073083N
(A) : for assemble, (B) : for remove
8.Press the fastener head with screw
driver and then pull the fastener
out from main service cover (7).
9.Pull the main service cover over 7
mm (0.28 in) to toward the front of
the vehicle.
10. Lift the main service cover up and
then remove the main service
cover. Be careful not to damage
the holder under the main service
cover.
11. Connect the jumper cables in the
exact sequence shown in the
illustration. First connect one end
A B
of a jumper cable to the positive
terminal of the jump start con-
nector (1), then connect the other
end to the positive terminal on
the booster battery (2).
Proceed to connect one end of
the other jumper cable to the
negative terminal of the booster
battery (3), then the other end to
OKH073084N
the negative terminal of the jump
start connector (4). Do not con-
nect it to or near any part that
moves when the engine is
cranked.
Do not allow the jumper cables to
contact anything except the cor-
rect battery terminals or the cor-
rect ground. Do not lean over the
battery when making connec-
tions.
6
6-7