Kia quoris Manual page 130

To adjust the Zone setting:
1.Determine the desired
Number based upon your current
location on the Zone Map.
2.Press and hold the
more than 3, but less than 6 sec-
onds, the current Zone Number will
appear on the display.
3.Pressing and holding the
again will cause the numbers to
increment (Note: they will repeat
...13, 14, 15, 1, 2, ...). Releasing
the button when the desired Zone
Number appears on the display will
set the new Zone.
4.Within about 5 seconds, the com-
pass will start displaying a com-
pass heading again.
There are some conditions that can
cause changes to the vehicle mag-
Zone
nets, such as installing a ski rack or a
CB antenna. Body repair work on the
vehicle can also cause changes to the
button for
vehicle's magnetic field. In these situa-
tions, the compass will need to be re-
calibrated to quickly correct for these
changes. To re-calibrate the compass:
button
1.Press and hold the
more than 6 seconds. When the
compass memory is cleared, a "C"
will appear in the display.
2.To calibrate the compass, drive the
vehicle in 2 complete circles at less
than 8 km/h (5 mph).
Integrated HomeLink
Wireless Control System
The HomeLink
System provides a convenient way to
replace up to three hand-held radio-
frequency (RF) transmitters with a
single built-in device. This innovative
feature will learn the radio frequency
codes of most current transmitters to
button for
operate devices such as gate opera-
tors, garage door openers, entry
door locks, security systems, even
home lighting. Both standard and
rolling code-equipped transmitters
can be programmed by following the
outlined procedures.
®
HomeLink information can be found
at: www.homelink.com or by calling
1-800-355-3515.
❈HomeLink
®
mark of Johnson Controls, Inc.
®
®
Wireless Control
Additional
is a registered trade-
4-51
4