Kia quoris Manual page 132

5. Press and hold the just-trained
®
HomeLink button and observe
the red Status Indicator LED. If the
indicator light stays on constantly,
programming is complete and
your device should activate when
®
the HomeLink button is pressed
and released.
6. To program the remaining two
®
HomeLink buttons, follow steps 2
through 5.
Rolling code programming
Rolling code devices which are
"code-protected" and manufactured
after 1996 may be determined by the
following:
• Reference the device owner's
manual for verification.
• The handheld transmitter appears
to program the HomeLink
Universal Transceiver but does not
activate the device.
• Press and hold the
®
HomeLink button. The device has
the rolling code feature if the indi-
cator light flashes rapidly and then
turns solid after 2 seconds.
To train rolling code devices, follow
these instructions:
1. At the garage door opener receiv-
er (motor-head unit) in the garage,
locate the "learn" or "smart" but-
ton. This can usually be found
where the hanging antenna wire is
attached to the motor-head unit.
Exact location and color of the
®
button may vary by garage door
opener brand.
If there is difficulty locating the train-
trained
ing button, reference the device
owner's manual or please visit our
Web site at www.homelink.com.
2. Firmly press and release the
"learn" or "smart" button (which
activates the "training light").
✽ NOTICE
There are 30 seconds in which to ini-
tiate step 3.
4
4-53