Yaesu CT-39A Operating Manual page 68

M
ENU
Menu #34 [ SCAN ]
Function: Selects the Scan-Resume mode.
Available Values: TIME/BUSY
Default: BUSY
TIME: The scanner will halt on a signal it encounters, and will hold five seconds. If you do
not take action to disable the scanner within five seconds, the scanner will resume
even if the stations are still active.
BUSY: The scanner will halt on a signal it encounters. Two seconds after the carrier has
dropped because the other station(s) ceased transmission, the scanner will resume.
Note: This Menu Item can be set independently for each band.
Menu #35 [ SCAN M ]
Function: Selects the Memory Scan mode
Available Values: MEM/MSM
Default: MEM
MEM: Enables Memory Scanning on all memory channels.
MSM: Enables Memory Scanning on "flagged" Memory Channels only.
Menu #36 [ SHIFT ]
Function: Sets the magnitude of the Repeater Shift.
Available Values: 0.00 - 99.95 MHz (50 kHz step)
Default: Depends on the band of operation.
Note: This Menu Item can be set independently for each band.
Menu #37 [ SKP.MSM ]
Function: Selects what action will happen on a "flagged" Memory Channel
Available Values: OFF/SKIP/MSM
Default: OFF
OFF: All memory channels will be scanned (the "flag" will be ignored).
SKIP: The scanner will "skip" the flagged ("SKIP") channels during scanning.
MSM: The scanner will "only scan" the flagged (Preferential) channels during scanning.
Menu #38 [ STEP ]
Function: Sets the Synthesizer steps.
Available Values: 5.0 k/10.0 k/12.5 k/15.0 k/20.0 k/25.0 k/50.0 k
Default: Depends on the band of operation.
Note: This Menu Item can be set independently for each band.
66
S M
ET ODE
FT-8800R Operating Manual