Initial Setup - Samsung series 5 User Manual

Initial setup

The initial setup dialogue box appears when the TV is first activated. Follow the on-screen
instructions to finish the initial setup process such as selecting the menu language, scanning
channels, connecting to the network, and more. During each step, either make a choice
or skip the step. You can manually perform this process at a later time in the
menu.
- If you connect any external device to
live TV signal is set to
channels and stores them in the TV's memory.
- If you want to connect aerial cable to your TV, select
scan all channels and stores them in the TV's memory.
Samsung's 'On TV' Recommendations Service
The service recommends TV programmes based on their popularity or your personal
On TV
preferences. To enjoy the On TV service, please follow the steps below. (You must have an
Internet connection.)
: Select the
1. Configure your TV
: Freeview, Freesat, DVB-T/C/S
Aerial
: External Cable Box, External Satellite Box
Set-top box
2. Auto tuning channels
3. Select a Service Provider
postcode and select your Freeview, Freesat or external satellite television provider from the
displayed list.
4. Set-top Box Control Test
Box. This step only occurs if '
Password Change
>
System Change PIN
To alter the default setting of the TV, change the password.
Changing the TV's password.
Run and then enter the current password in the password field. The default
1. Change PIN
password is "0-0-0-0".
Enter a new password and then enter it again to confirm it. The password change is
2.
complete.
- If you forgot your PIN code, press the buttons in the following sequence to reset the PIN to
"0-0-0-0":
In Standby mode:
HDMI1
. After finishing with this process, you will not be able to scan all
STB
source to be used for
TV
: This step only occurs if '
: To select your preferred programme provider for On TV, enter your
: This test is to check if your TV remote is able to control your Set-top
Set-top box
→ 8 → 2 → 4 →
MUTE
English - 19
before starting initial setup, the source of your
. In this case, you will be able to
Aerial
.
On TV
' was selected in step 1.
Aerial
' was selected in step 1.
(On)
POWER
>
System Setup