Using Weather Search And Weather Alert (Same); Searching For A Weather Broadcast; Using Weather Alert (Same) - Uniden APCO25 Owner's Manual

Using Weather Search and Weather Alert (SAME)

Your scanner allows you to either search for a local NOAA weather broadcast, or be set to
alert when a SAME weather alert is broadcast on a NOAA channel.

Searching for a Weather Broadcast

To search for a weather broadcast in your area:
1:SERVICE OPTION → 1:WEATHER → 1:MONITOR
The scanner begins to search the frequencies used by the National Weather Service for
these broadcasts. When it finds a broadcast, it stops on the channel until you select another
option or reception of the signal stops.
Note: NOAA broadcasts are continuous broadcasts. You will only lose reception if you
move out of a coverage area. If the signal is lost, the scanner resumes searching for
a weather transmission.

Using Weather Alert (SAME)

Important: Your scanner has been primarily designed to be a radio scanner. While it
incorporates weather alert as one feature, we strongly recommend that you not use the
scanner as your sole means for receiving emergency alerts. Your local electronics retailer
carries several weather radios specifically designed for this function.
SAME (Specific Area Message Encoding) was adopted late in the last century to replace the
wide-area alerts previously used. Weather alerts today are preceded by a digital packet that
identifies not only the type of alert, but also the geographic location for the alert. Thus, it is
possible for a weather broadcast that can be received across many counties to be targeted
to a single county.
To specify a county, SAME uses a standard established by the US Census bureau, called
FIPS. The format of a FIPS code is:
DSSCCC
Where
D = area subdivision (0=entire area)
SS = State code (00=all states)
CCC = County code (000=all counties)
For example, the FIPS code for Tarrant County, Texas is:
048439 (48=Texas; 439=Tarrant County).
Some counties are further subdivided, in which cases, the first digit will be 0 for all
subdivisions in the county and each subdivision will be labeled 1-9.
To program your scanner to alert you when the weather service issues an alert, you must
set the scanner to the alert mode, and then leave the scanner monitoring the weather
service. You cannot scan and monitor for weather alerts at the same time.
32