Table of Contents
Advertisement
FINAL ASSEMBLY
Attach the base to the chassis with four M15 X 4
screws and rubber feet (see Figure W).
Apply the bottom label as shown.
Apply the back label as shown in Figure X.
M15 x 4 Screws
Figure W
!
Rubber Feet
Disconnect power supply cord before
servicing unit.
M15 x 4 Screws
Warning: 300W Max.
Input Voltage: 120V 60Hz
WARNING
Shock Hazard
Made in China
Figure X
Assemble the iron holder as shown in Figure Y
below. Insert the iron holder into the slot on either
the right or the left side as shown in Figure Y. Set
the power switch to the OFF position.
Figure Y
Bottom
Note: Make sure tab
Label
goes into key hole.
Soldering iron
holder body
-14-
Left Side Mount
Right Side Mount
Soldering iron holder
Bracket
Iron Holder
Note: Twist
clockwise
once inserted.
Knob
Advertisement
Table of Contents
