Installing Quick Sink Adapter; Preparation Before Washing - RCA RPW160 Instruction Manual

Installing Quick Sink Adapter

When installing the quick sink faucet adapter to the faucet, follow the steps below:
1.First,remove the aerator from your faucet nozzle and determine the size/type of
the faucet.
2.Once you determine the size/type of the faucet(Outside Threaded End or Inside
Threaded End),place the proper sized rubber washer into the silver faucet adapter.
3.Attach the silver faucet connector to the faucet.
4.Attach the faucet connector to the water inlet hose and make sure that the rubber
washer is placed in between.
5.Attach the other end of the water inlet hose to the washer water inlet and make
sure that the rubber washer is placed in between.
Faucet Adapter
Quick Connector
Water inlet hose
Washer
Drain hose
Washers
Faucet
Washer
Rear View of Washer
8

Preparation before washing

Adjust the adjustable foot to make
1
the washer be placed stable.
Adjustable foot (extend when
clockwise rotating and shorten
when counterclockwise rotating)
(Slightly incline the washer first and loosen the
adjustable foot knob. Adjust the adjustable foot so
as to ensure four corners of washer be steadily
contacted with the ground. Then tighten the
adjustable foot knob and lock it. If the ground is
obviously not flat, correction should be made on
the ground surface, otherwise the washer barrel
will incline and knock the cabinet)
Put down the drain
Connect with to
3 5
hose.
power source.
Upper drain
Note:
Turn on the
4 The water
will overflow
water supply.
when the
height of
the drain
hose under
860mm.
Before washing, please do take out coins,
NOTICE
keys and other hard goods, and zip up clothes
！
tightly to prevent them and barrel from damage.
Install the water
2
inlet hose.
For two inlet hoses
Put in
6
clothes
and
suitable
amount of
washing
powder.
9