Quick-Start Demo - Fisher F2 Operating Manual

QUICK-START DEMONSTRATION
I. Supplies Needed
• A Nail
• A Zinc Penny (dated after 1982)
II. Position the Detector
a. Place the detector on a table,
with the searchcoil hanging
over the edge. (or better, have
a friend hold the detector, with
the coil off the ground).
b. Keep the searchcoil away from
walls, floors, and metal objects.
c. Remove watches, rings and
other jewelry or metal objects
from hands and wrists.
d. Turn off appliances or lights that cause electromagnetic interference.
e. Pivot the searchcoil back toward the detector body.
III. Power Up
Press .
NOTE: Immediately after powering
on, your detector's unique 10-digit
serial number is displayed once on
the LCD. Two digits are displayed at
a time; five 2-digit numbers are
displayed in sequence. This 10-digit
serial number is the same serial
number imprinted on the label inside the battery compartment.
IV. Wave each Object over the
a.Notice a different tone for each object.
Low Tone:
Low Mid Tone:
Medium Tone:
High Tone:
b.Motion is required. Objects
must be in motion over the
searchcoil to be detected.
V. Press DISCRIMINATION
a. The first press illuminates
all target icons.
b. The second press turns
off the "IRON" icon.
Quick-Start Demo continued
on next page
Nail
Nickel
Zinc Penny
Quarter
Twice
• A Quarter
• A Nickel
Search Coil
5