Batteries; Headphone Jack - Fisher F2 Operating Manual

BATTERIES

Two 9-Volt batteries are
supplied with the F2.
The batteries have been inserted
backwards in the compartment
for storage during transportation.
Please remove batteries, turn
them around, and install
correctly.
Use ALKALINE batteries only.
DO NOT MIX OLD AND NEW BATTERIES.
To install the batteries:

1
Remove the battery cover by
disengaging the clip at the back.
Do not hinge door upward; pull straight back

2
Align the polarity of the batteries correctly, with the positive "+" toward the
coil plug connection, as indicated by the + indicator on the housing.

3 Insert (2) 9-Volt ALKALINE batteries, with the contacts pointed inward, and
press down on the back of the batteries to snap them into place.
Some brands of batteries will require moderate force to clear the
retaining tabs.

4 Replace the battery door.
Most metal detector problems are due to improperly installed batteries, or
the use of non-alkaline or discharged batteries. If the detector does not turn
on, please check the batteries.
BATTERY DISPOSAL & RECYCLING
Alkaline batteries may be disposed of in a normal waste receptacle or
recycled. Non-Alkaline batteries should be recycled. In the state of California
all battery types must be recycled. Please refer to local municipalities for
detailed disposal and recycling requirements.
USING HE DPHONES
Using headphones (not included) improves
battery life, and prevents the sounds from
annoying bystanders.
It also allows you to hear subtle changes in the
sound more clearly, particularly if searching in a
noisy location. For safety reasons, do not use
headphones near traffic or where other
dangers are present. This device is to be used
with interconnecting
cables shorter than three meters.
4
cables/headphone