Troubleshooting - Q Acoustics Q-TV2 Quick Start Manual

Sound
Indicator Light check
Green - Signal being received, Check the volume of your source equipment / Q-TV2
Red - No Signal received, Check AUDIO connections.
Orange - SET DELAY switch is in operation, set to NORMAL position
No Light - Check power connections / Check switch on power supply
Poor Sound
Check connections are firmly connected to both the TV and Q-TV2
Check that you have selected the best quality connection method
Ensure that you have only used the connection methods outlined in this manual
Ensure that you have not connected a line level output to a mini jack input
Check that you TV's audio out is set to PCM mode (Optical Only)
Two sources are audible at the same time
Make sure that only one source is on at one time
Turn off the second source
Q-TV2 audible when TV in Standby
On some TV's the outputs remain active even when the TV is in standby. If this is the
case then turn off the Q-TV2 power when the TV is not in use
No Volume Control (Mini Jack Connection)
Make sure that the SOURCE VOLUME switch is in the NORMAL position
Make sure the headphone socket volume is controlled by your TV Remote
Check the connections diagram on page 9
No Volume Control (RCA /PHONO Connection)
Make sure you are using the supplied Q-TV remote to control the volume
Make sure that the SOURCE VOLUME switch is in the NORMAL position
Make sure the TV IN socket is left vacant
Check if your TV has a variable line out, consult manufacturers guide for details
No Volume Control (Optical Connection)
Make sure you are using the supplied Q-TV remote to control the volume
Make sure that the SOURCE VOLUME switch is in the NORMAL position
Make sure the TV IN socket is left vacant
Make sure the TV digital out is set to PCM Mode
Check if your TV has a variable digital out, consult manufacturers guide for details

Troubleshooting

Page 17