Theft Protection; Lost Or Damaged Keycard - Blaupunkt Frankfurt C70 Operating Instructions Manual

Remove the first KeyCard.
"INSERT" appears on the display.
Insert the new KeyCard.
"LEARN OK" appears on the display.
To leave the KeyCard menu,
press the MENU button 8 once or OK
5 repeatedly until the desired menu
appears. The settings are now stored.
You can now use your car radio with the new
KeyCard.
Note:
A maximum of two KeyCards can be used for
each unit.
If you already have two Keycards for your unit
and you make a third KeyCard "learn", you
will no longer be able to use the unit with the
KeyCard not used during the "learning" pro-
cess.

Lost or damaged KeyCard

If all KeyCards belonging to the car radio are
damaged or lost, a new KeyCard must first
be made to "learn" the unit's master code,
which can be found in your car radio pass.
Always keep your car radio pass in a
safe place, but never in your car.
To find out how to prepare a new Keycard for
use, please read the section "Making a new
KeyCard "learn" the code/entering the mas-
ter code".
If necessary, you can use this KeyCard to
make a second KeyCard learn the code. To
find out how to do this, please read the sec-
tion "Making a second KeyCard "learn"/replac-
ing the KeyCard".
You can obtain new KeyCards from your spe-
cialist dealer.

THEFT PROTECTION

Making a new KeyCard "learn" the
code/entering the master code
If you no longer have a valid KeyCard for your
unit and would like to make a new KeyCard
learn the code:
insert the new KeyCard, which the unit
does not recognise;
close the operating panel;
if necessary, switch off the radio;
Hold down the TUNE button > and the
second soft key from the top on the left
4 at the same time;
switch the unit on using button 2.
"0000" then appears on the display.
Enter the four-digit master code from your car
radio pass as follows:
enter the number of the master code
using the and
press the buttons repeatedly until the
desired number appears on the display;
alter the input position using the
buttons 7;
When the master code is correctly dis-
played, press the OK button 5.
The new KeyCard is accepted when the unit
switches to playback..
Optical theft protection display
(LED)
The ON button and the drive-compartment
lights may flash when the unit is switched off
and the KeyCard removed. For this, the "LED"
menu setting must be at "on".
Press the MENU button 8.
Press the soft key 4 with the display
allocation "KC".
Press the soft key 4 with the display
allocation "LED".
The current status "LED ON" or "LED OFF"
appears on the display.
buttons. To do this,
43