Adjusting Feet; Appropriate Installation Location; Under Counter Installation; Electrical Connection - Beko DC 1160 Instruction Manual

2
Installation
Refer to the nearest Authorised Service Agent
for installation of your product.
C
Preparation of location and electrical
installation for the product is under
customer's responsibility.
B
Installation and electrical connections must
be carried out by a qualified personnel.
A
Prior to installation, visually check if the
product has any defects on it. If so, do not
have it installed. Damaged products will
cause risks for your safety.

Appropriate installation location

• Install the product in an environment which
has no risk of freezing and is in a stable and
level position.
• Operate your product in a well ventilated,
dust-free environment.
• Do not block the air ducts in front of and
under the product with materials such as
long pile rugs and wooden bands.
• Do not place your product on a long pile rug
or on similar surfaces.
• Do not install the product behind a door
with a lock, sliding door or a hinged door
which can strike the product.
• Once the product is installed, it should stay
at the same place where its connections
have been made. When installing the
product, make sure that the rear wall of it
does not touch anywhere (tap, socket, etc.)
and also pay attention to install the product
at a place where it will stay permanently.
B
Do not place the product on top of the
power cable.
• Keep at least 1.5 cm distance to walls of
other furniture.

Under counter installation

• A special part (Part no: 295 970 0100)
replacing the top trim must be provided and
installed by the Authorised Service Agent in
order to use the machine under a counter or
in a cupboard. It should never be operated
without the top trim.
• Leave at least 3 cm of space between
the side and rear walls of the product and
the walls of the counter/cupboard when
installing your product under a counter or in a
cupboard.

Mounting over a washing machine

• A fitting device should be used between
the two machines when installing above a
washing machine. The bracket (Part no. 296
280 0100 white/296 280 0200 grey) must be
installed by the Authorised Service Agent.
• Place the product on a firm floor. If it will be
placed on top of a washing machine, the
approximate weight of both machines may
reach 180 kg when they are full. Therefore,
the floor must be capable of carrying the load
on it!

Adjusting feet

In order to ensure that your product operates
more silently and vibration-free, it must stand
level and balanced on its feet. Front feet of your
product can be adjusted. Balance the machine
by adjusting the feet.
1. Loosen the feet by hand.
2. Adjust the feet until the product stands level
and firmly on the floor.
C
Do not use any tools to loosen the adjustable
feet, otherwise, they can be damaged.
C
Never remove the adjustable feet from their
housings.
2 plastic pieces supplied along with the user
manual prevent your machine from slipping on
wet and slippery surfaces. To install the plastic
parts:
1. Tilt your product to backwards.
2. Fit the plastic parts on to the front adjustable
feet. Press on the plastic parts to snap them
into their seating.
3. Check the balance of your product again and
readjust the adjustable feet if necessary.

Electrical connection

Connect the machine to a grounded outlet
protected by a fuse of suitable capacity as
stated in the technical specifications table. Our
company shall not be liable for any damages
that will arise when the machine is used on a
circuit without grounding.
• Connection must comply with national
regulations.
• If the current value of the fuse or breaker
in the house is less than 16 Amps, have a
qualified electrician install a 16 Amp fuse.
• Power cable plug must be within easy reach
after installation.
• The voltage and allowed fuse or breaker
protection are specified in the "Technical
Specifications" section.
5 EN