Epson l805 User Manual page 69

User's Guide
Light
* In some print cycles a very small amount of surplus ink may be collected in the ink pad. To prevent ink leakage
from the pad, the printer is designed to stop printing when the pad has reached its limit. Whether and how often
this is required will vary according to the number of pages you print, the type of material that you print and the
number of cleaning cycles that the printer performs. The need for replacement of the pad does not mean that your
printer has ceased to operate in accordance with its specifications. The printer will advise you when the pad
requires replacing and this can only be performed by an authorised Epson Service provider. The Epson warranty
does not cover the cost of this replacement.
Related Information
"Loading Paper in the Rear Paper Feed" on page 16
&
"Loading a CD/DVD" on page 19
&
"Contacting Epson Support" on page 88
&
"Updating Applications and Firmware" on page 67
&
Checking the Printer Status - Windows
1. Access the printer driver window.
2. Click EPSON Status Monitor 3 on the Maintenance tab.
Note:
❏ You can also check the printer status by double-clicking the printer icon on the taskbar. If the printer icon is not
added to the taskbar, click Monitoring Preferences on the Maintenance tab, and then select Register the shortcut
icon to the taskbar.
❏ If EPSON Status Monitor 3 is disabled, click Extended Settings on the Maintenance tab, and then select Enable
EPSON Status Monitor 3.
Solving Problems
Situation
A printer error has occurred.
Wi-Fi connection error has
occurred.
The printer has started in
recovery mode because the
firmware update failed.
Solutions
Open the printer cover and remove any paper or protective
material inside the printer. Turn the power off and on
again.
If the error continues to occur after turning the power off
and on again, contact Epson support.
Hold down the button for more than three seconds
to clear the error. See the Network Guide and try the Wi-Fi
connection again.
Follow the steps below to try to update the firmware again.
1. Connect the computer and the printer with a USB cable.
(During recovery mode, you cannot update the firmware
over a network connection.)
2. Visit your local Epson website for further instructions.
The printer notifies you of the firmware update status as
shown below.
Preparing: The network status lights flash.
Updating: The power light flashes.
Finished: The power light stays on.
69