ELECTRICAL FEEDER CABLE CONNECTION
WARNING: If the power supply cable is damaged, it must be replaced only by an
authorised service agent in order to avoid a hazard.
To connect the supply cable:
•
Remove the screw that holds shield "A" behind the cooker (fig. 11.1).
•
Insert the feeder cable of the suitable section (as described in the next chapter) into
the cable clamp "D" .
•
Connect the wires to the terminal block "B" according to the diagram in figure 11.2.
•
Pull the feeder cable and secure it with cable clamp "D" .
•
Re-mount shield "A" .
NOTE: The earth conductor must be left about 3 cm longer than the others.
POWER SUPPLY
230 V~ 50 Hz
3785 W
FEEDER CABLE SPECIFICATIONS
Type "H05RR-F"
3 x 2,5 mm
2
B
A
Fig . 11 .1
PE
N
D
L
230 V~
L
N
1
(L
2
Fig . 11 .2
PE
)
37