Clean Your Coffeemaker Before Using The First Time; Setting The Clock And Delay Brew Time - Mr. Coffee SJ Series User Manual

• Programmable Controls:
– Clock – The clock serves as a handy kitchen clock
and allows you to set the Delay Brew feature and
functions as the Fresh Brew™ Timer feature.
– Fresh brew™ Timer feature – Lets you know how
long your coffee has been waiting for you.
– Delay brew – Would you like to wake up to a
fresh pot of coffee? The timer allows you to
preset when you would like the coffeemaker to
automatically begin brewing your coffee, up to 24
hours in advance.
NOTE: If you have selected any of the operating
functions, the coffeemaker will act upon the last
operation selected if the power is restored within 10
seconds after a power outage.
CLEAN YOUR COFFEEMAKER bEFORE USING ThE
FIRST TIME
Make sure your first cup of coffee is as good as can be
by cleaning your MR. COFFEE
first use. Just follow these simple steps:
1. Wash the decanter, decanter lid and the filter
basket in a mixture of mild detergent and water.
Rinse each thoroughly (please refer to the parts
diagram).
2. Replace all the parts and close the lid. Then, run a
brew cycle with water only, without adding coffee
and coffee filter.
3. When brewing is complete,
turn your coffeemaker off,
discard the water in the
decanter and rinse the
decanter, decanter lid, and
filter basket.
10
BVMC-SJX_12ESM1.indd 11-12
Coffeemaker before its
®

SETTING ThE CLOCK AND DELAY bREW TIME

To Set the Clock:
1. Plug the power cord into a standard
electrical outlet. The clock will flash on
the control panel to indicate that the
time has not been set yet.
2. Press and hold the HOUR and MINUTE
buttons until you reach the current
time.The AM or PM indicator will light
up along the left side of the display.
(Figures 1 and 2).
NOTE: Pressing any button before setting
the clock will cause the clock to start keeping
time from 12:00 a.m. You must set the clock if
you want to use the Delay Brew feature.
To Set the Delay brew Time:
While the display is in the clock mode,
simply press the SET DELAY button
(Figure 3) and, while the DELAY BREW time
is flashing, set the brew time by pressing the
HOUR and MINUTE buttons. The AM or PM
indicator will light up along the left side of
the display. (Figure 4)
Within a few seconds the display will
change to the current time.
NOTE: To activate the DELAY BREW cycle,
see the "brewing Coffee Later" section.
To check the programmed time, push the
SET DELAY button. The display will show the
time you have programmed the coffee to
brew. If you press the SET DELAY button again or wait a
few seconds, the display will switch back.
Figure 1
Figure 2
Figure 3
Figure 4
11
10/8/12 4:15 PM