Table of Contents
Advertisement
Table 1 provides information on the user-related features of the SG2-DRT-3X.
Key
Feature
1
OPTICAL
POWER
(1 V/mW)
2
F
A
U
L
O
T
N
ALARM
3
I
N
P
U
T
A
4
I
N
P
U
T
B
5
Figure 3 illustrates a side view of the SG2-DRT-3X and indicates the laser warning label.
Figure 3
SG2-DRT-3X side view and laser warning label
Description
This test point enables monitoring of the optical output level of the module.
The nominal scale factor is 1.0 V/mW (6.3 V equates to 8 dBm). The optical
power test point does not track changes in optical power due to the laser
tracking error.
A red (
) LED indicates that the laser output power is below normal
FAULT
limits.
A green LED (
) indicates the transmitter is enabled.
ON
Because the laser output requires a short period of time to stabilize, it is
normal for neither LED to illuminate for approximately 10 seconds. The
module must be enabled for the fault indicator to function.
This MCX connector provides the SG2-DRT-3X with channel A RF input
through a cable connection to the node lid board in an SG2440 or the E-pack
in an SG2000.
This MCX connector provides the SG2-DRT-3X with channel B RF input
through a cable connection to the node lid board in an SG2440 or the E-pack
in an SG2000.
Channel C RF input is provided by direct connection of the node lid board
with the D-type connector on the bottom of the SG2-DRT-3X.
This SC/APC-type connector provides optical output from the SG2-DRT-3X.
DANGER
INVISIBLE LASER RADIATION WHEN OPEN
PEAK POWER 10 mW
CLASS
THIS PRODUCT COMPLIES WITH 21CFR
CHAPTER 1 SUBCHAPTER J
STARLINE
I
LASER PRODUCT
SG2-DRT-3X Installation Sheet
3
Advertisement
Table of Contents
