Toyota 2011 Sienna Owner's Manual page 48

1-2. Operating the AUTO ACCESS SEAT
n Operating conditions
Under the following conditions, the seat will not rotate or lower even if the
seat lower switch is pressed.
l The right-hand sliding door is not opened completely.
l The seat belt is caught up in the AUTO ACCESS SEAT.
l The shift lever is not in P.
n Wireless remote control
l The AUTO ACCESS SEAT will operate when the seat lower switch has
been pressed and the beep has sounded once.
l The AUTO ACCESS SEAT will stop if the seat lower switch is released
during operation.
n Jam protection function
If the operation of the AUTO ACCESS SEAT is interrupted by collision with
an obstacle etc., the beep will sound twice and the seat will retreat slightly
and then stop. If this happens, make sure that the hands, feet etc. of the
occupant will not hit the body of the vehicle, and operate the seat once again
after removing the obstacle.
n Conditions which will halt operation
If another wireless remote control or the seat raise/lower switch are operated
while the AUTO ACCESS SEAT is being operated by wireless remote con-
trol, the AUTO ACCESS SEAT will stop operating.
28
SIENNA AAS_U (OM45460U)