Troubleshooting 6 Blinks Failure - Panasonic TC-PXXGT30 Technical Manual

Blink
Code
Main Suspect
6 Blinks SC
Cautions: Disconnect the AC Power prior to making any disconnection or connection.
If the power LED continues to blink even after the TV is unplugged, press and hold the power switch on
the TV for a few seconds until the LED turns off.
When taking voltage reading, place the voltmeter probe at the test point, component, or connector's pin
indicated before connecting the TV to the AC line. This will ensure voltage reading accuracy before the
TV shuts down. (Since the TV is shutting down, expect the voltage to only come up a couple of seconds.)
Check connections between the A board and the C and SC boards. Make sure that all connectors are properly seated. Unplug the TV and remove
Unplug the TV and get
ready to measure the
voltage at pin 13 of
connector P6. Plug in the
TV and turn it on.
Replace the P
board

Troubleshooting 6 Blinks Failure

List of boards likely to cause this symptom.
nd
2
A
connectors SC20 from the SC board. Connect the TV and turn it on.
No
Still 6 Blinks
No
rd th
3 4
P
Start Here
Yes
Did the number
of blinks
changed?
Yes
Is there
15V
present?
th th
5 6
Replace the SC
8 Blinks
board
Replace the A
board
th
7
Slide 47