When Aerial Source is set to Terrestrial or Cable
Digital Channel Tuning
●
Scans for a digital channel.
1.
Select the New.
"
When selecting
"
When selecting
2.
Select the Search. When scanning has finished, a channel is updated in the channel list.
Analogue Channel Tuning
●
Scans for an analogue channel.
1.
Select the New.
2.
Set the Programme,
3.
Select the Store. When scanning has finished, a channel is updated in the channel list.
Channel mode
P
●
(programme mode)
When tuning is complete, the broadcasting stations in your area have been assigned to position
numbers from P0 to P99. You can select a channel by entering the position number in this mode.
C
●
(aerial channel mode) /
These two modes allow you to select a channel by entering the assigned number for each aerial
broadcasting station or cable channel.
Fine-Tuning the Screen
Broadcasting
Channel Settings
>
"
Available for analogue broadcasts only.
Analogue pictures can become shaky and full of noise. If this happens, you can fine-tune the signal
and/or reduce noise to clear up the picture.
1.
Channel Settings
Select
2.
l
r
Press the
or
Reset
Select
to reset the Fine-Tune operation.
Aerial
→ Terrestrial: Channel, Frequency,
Aerial
→ Cable: Frequency, Modulation,
Colour
System,
S
(cable channel mode)
Fine Tune
>
Fine
Tune. An adjustment bar appears on the screen.
>
button to make adjustments. Select
Bandwidth
Symbol Rate
Sound
System,
Channel
Try Now
Save
and Search.
Close
or
to apply the new setting.