Basic Setup - Motorola m25 User Manual

Basic Setup

Connections
Before you can start using your new m25 player, you'll have to install and connect a few things. This chapter describes
how to install the battery and a memory card, and connect the player to the earphones and the Mini USB cable.
Battery/Memory Card
The m25 uses a single AAA battery that provides many hours of use. Either an alkaline (regular or rechargeable) or a
nickel-metal hydride (NiMH) battery can be used. The
can be installed. To remove the battery compartment cover:
1 Press in the small latch while lifting off the back cover of the player. (See the picture on page 10.)
2 If you want to install a memory card, slide it into the slot as shown on page 10.
3 Install the battery with the flat end (the negative/- end) against the curled spring.
4 Snap the cover back on. Make sure it's lined up properly with the slots in the player body and the cutout for the
Thumbstick.
Earphones
Connect the supplied earphones to the earphone jack on the top of the player (see page 9). Any quality audio
earphones with a 3.5 mm stereo plug can be used with the m25. DO NOT use an earphone from a cell or cordless
phone because the wiring is different and can damage the player.
m25 DIGITAL AUDIO PLAYER
battery compartment cover must be removed before a battery
14