Sony HD-IS10 Service Manual page 7

QQ
3 7 63 1515 0
DVD MECHANISM DECK SERVICE POSITION
• In checking the DVD mechanism deck, prepare two extension jigs
(J-2501-086-A: 19 cores, 300 mm/J-2501-102-A: 13 cores, 300 mm).
FL board
Connect jig (extension cable J-2501-102-A)
to the MAIN board (CN106) and wire (flat type) (13core).
TE
L 13942296513
NOTE WHEN REMOVING OPTICAL PICK-UP BLOCK
www
.
http://www.xiaoyu163.com
REG board
MAIN board
DVD mechanism deck
Be sure to bridge here, and then disconnect the
wire (flat type) (24 core).
(optical pick-up block will be destroyed without bridging.)
On the contrary at the installation, connect the
wire (flat type) (24 core) first, and then remove the bridge.
Note: For a soldering iron, use the one with a ground wire.
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
Connect jig (extension cable J-2501-086-A)
to the MAIN board (CN105) and wire (flat type) (19core).
Q Q
3 6 7 1 3 1 5
wire (flat type) (24 core)
Note: Do not remove the wire (flat type) (24 core) (CN101).
If you remove the wire (flat type) (24 core) (CN101),
solder the bridge of optical pick-up.
co
.
HCD-IS10
9 4 2 8
wire (flat type) (21 core)
0 5 8 2 9 9 4 2 8
DMB-IVHD board
wire (flat type) (13 core)
m
9 9
9 9
7