Craftsman 315.115790 Operator's Manual page 12

TO INSTALL/REMOVE BATTERY PACK
See Figure 3.
TO INSTALL:
Place the battery pack in the saw aligning raised rib

on battery pack with groove in saw's battery port.
Make sure the latches on each side of the battery

pack snap into place and battery pack is secured to
saw before beginning operation.
CAUTION:
When placing battery pack in the tool,
be sure raised rib on battery pack aligns with the
bottom of the saw and latches into place properly.
Improper installation of the battery pack can cause
damage to internal components.
TO REMOVE:
Locate latches on side of battery pack and depress

both sides to release battery pack from the saw.
Remove battery pack from the saw.

BATTERY PACK
DEPRESS LATCH TO
RELEASE BATTERY PACK
OPERATION
TO INSTALL SAW BLADE
See Figure 4.
Remove battery pack.

Lift blade clamp lever located on side of saw.

Insert saw blade between blade clamp and saw bar.

Lock blade clamp lever.

Replace battery pack.

BLADE
BATTERY PORT
BLADE SELECTION
To obtain the best performance from the saw, it is
important to select a specific blade for the particular
application and type of material you wish to cut. By doing
LATCH
this, you will get a smoother, faster cut and prolong blade
life. Replacement blades for this saw are available from
your nearest Craftsman dealer.
Fig. 3
12
BLADE
CLAMP LEVER
BLADE CLAMP
BLADE SHOWN
CORRECT IN SAW BAR
TO INSTALL /
TO RELEASE
TO LOCK
Fig. 4