License Plate Lamp - Chevrolet Equinox 2016 Manual

222 Vehicle Care
4. Pull the taillamp assembly out
of the vehicle body.
5. Disconnect the lamp wiring
harness.
6. Turn the bulb socket
counterclockwise and pull
it out.
7. Pull the bulb straight out of the
socket.
8. Install the new bulb.
9. Push the bulb socket in and
turn it clockwise.
10. Reverse steps 2 5 to reinstall
the lamp assembly.

License Plate Lamp

Lamp Assembly
Bulb Assembly
1. Bulb Socket
2. Bulb
3. Lamp Assembly
To replace one of these bulbs:
1. Open the liftgate partway. See
Liftgate 0 32.
2. Push the left end of the lamp
assembly toward the right.
3. Pull the lamp assembly down
to remove it from the liftgate.
4. Turn the bulb socket (1)
counterclockwise to remove it
from the lamp assembly (3).
5. Pull the bulb (2) straight out of
the bulb socket (1).
6. Push the replacement bulb
straight into the bulb socket
and turn the bulb socket
clockwise to install it into the
lamp assembly.
7. Push the lamp assembly into
the liftgate engaging the clip
side first.
8. Push on the lamp side opposite
the clip until the lamp assembly
snaps into place.