Mitsubishi Triton MN 203p Installation Instructions Manual page 6

MITSUBISHI TRITON 3 PIECE TONNEAU COVER
23
REMOVE THE MASKING TAPE FROM THE HEADER RAIL AND APPLY RUST INHIBITOR TO DRILLED HOLES.
FIG. 16
NOT SUPPLIED
11
APPLY SILICON TO THE UNDERSIDE OF THE BOTTOM HINGES AS SHOWN AND POSITION THEM ON THE HEADER RAIL.
FIG. 17
PLACE RETAINER CLIPS (WITH TAG FACING LEFT) OVER FRONT OF BOTTOM HINGES. SECURE THE BOTTOM HINGES AND THE
RETAINER CLIPS TO THE HEADER RAIL USING POP RIVETS AS SHOWN.
FIG. 18
24
18
18
CLEAN HEADER RAIL AND HINGES (WHERE EXTRUSION WILL SIT) WITH ALCOHOL WIPES PROVIDED AND WIPE AWAY RESIDUE
WITH A DRY CLEAN CLOTH. PLACE THE EXTRUSION TAPE SEAL ALONG THE TOP OF THE HEADER RAIL WITH THE SEALING
LIP FACING TOWARDS THE TAILGATE. START THE EXTRUSION AT THE EDGE OF THE SIDE RAIL. IMPORTANT: POSITION
EXTRUSION AS CLOSE TO THE HEADER RAIL REAR RADIUS. RUB DOWN FIRMLY TO ENSURE MAXIMUM ADHESION.
FIG. 19
Page 6 of 13
1
REMOVE
MASKING
2
1
11
AS CLOSE TO REAR RADIUS
REAR
12
ISSUE05
TAPE
APPLY RUST
INHIBITOR
2
11
NOTE: SEALING LIP
MUST FACE TAILGATE
START EXTRUSION
AT EDGE OF SIDE RAIL
POSITION EXTRUSION
11
11
12
18
11
HEADER
RAIL
TC0169e
10
12
29/10/10