Table of Contents
Advertisement
MITSUBISHI TRITON 3 PIECE TONNEAU COVER
Ø5mm
10mm
23
POSITION LOCK STRIKER SUPPORT BRACKET UNDER THE LOCK STRIKER BRACKET AND ALIGN THE HOLES CLOSEST TO THE
FRONT OF THE VEHICLE AS SHOWN. MARK AND CENTRE PUNCH HOLE POSITION IN THE SIDE OF THE TUB. DRILL Ø5mm HOLE
FIG. 8
AND APPLY RUST INHIBITOR. REPOSITION LOCK STRIKER SUPPORT BRACKET AND SECURE TO THE TUB WITH A RIVET.
ASSEMBLE U BOLT, WASHERS AND NUTS ONTO LOCK STRIKER AND LOCK STRIKER SUPPORT BRACKETS AS SHOWN. ADJUST
SO THE TOP OF THE U BOLT IS 13MM DOWN FROM THE TOP OF THE SIDE RAIL. LAY STRAIGHT EDGE ACROSS THE CORNER OF
THE TUBE AND TAILGATE TO ASSIST MEASUREMENT OF U BOLTS. TIGHTEN ENSURING THE 13MM TO THE TOP OF THE SIDE
FIG. 9
RAIL IS MAINTAINED.
1
21
MEASURE THE LENGTH OF EXPOSED THREAD (X MM) FROM THE BOTTOM OF THE NUT TO THE END OF THE THREAD.
MEASURE LENGTH (X MM) ON THE RUBBER THREAD CAP AND CUT TO LENGTH AS SHOWN.
REPEAT FOR FOUR (4) RUBBER THREAD CAPS AND FIT TO THREADS.
FIG. 10
PASSENGER'S SIDE
10
ATTACH THE GAS STRUT BRACKETS (BOTH SIDES) TO THE SIDE RAILS USING POP RIVETS AS SHOWN.
FIG. 11
Page 4 of 13
1
ALIGN HOLES
4
16
21
9
8
20
9
2
CUT AWAY
SHADED
AREA
X (mm)
4
22
CENTRAL POSITION OF BED
5
2
MARK, CENTRE PUNCH,
DRILL Ø5mm HOLE
APPLY RUST INHIBITOR
4
16
X (mm)
ISSUE05
16
SIDE VIEW
MEASURE FROM TOP OF
SIDE RAIL
13mm
4
21
3
21
22
DRIVER'S SIDE
10
TC0169e
3
10
13mm
5
29/10/10
Hide quick links:
Advertisement
Table of Contents
