Mitsubishi Triton MN 203p Installation Instructions Manual page 5

MITSUBISHI TRITON 3 PIECE TONNEAU COVER
FIND THE CENTRE OF THE BED AND MARK THE POSITION.
FIG. 12
MEASURE AND MARK THE POSITIONS AS INDICATED ABOVE FROM THE CENTRE OF THE BED FOR THE PLACEMENT OF
THE BOTTOM HINGES. WARNING:- RECHECK DIMENSIONS TO ENSURE CORRECT MEASUREMENT.
FIG. 13
1
ALIGN HINGE
WITH PREVIOUSLY
MARKED POSITION
POSITION THE BOTTOM HINGES ON THE HEADER RAIL, ALIGNING THEM WITH THE PREVIOUSLY MARKED POSITIONS AS SHOWN.
MARK THE THREE (3) HOLE POSITIONS OF EACH HINGE AND REMOVE THEM FROM THE VEHICLE.
FIG. 14
20mm
CENTRE PUNCH AND DRILL Ø5MM HOLES AT THE PREVIOUSLY MARKED POSITIONS.
FIG. 15
Page 5 of 13
A = B (CENTRAL POSITION)
A
CENTRAL POSITION OF BED
382.5mm
11
MARK THREE (3)
HOLE POSITIONS
Ø5mm
B
FIND CENTRE AND
MARK POSITION
382.5mm
MARK POSITIONS ON
TOP OF HEADER RAIL
2
x2
ISSUE05
11
CENTRE PUNCH,
THEN DRILL Ø5MM
HOLES (x6)
TC0169e
29/10/10