Monitor Panel - Fleetwood Pace Arrow 2000 Manual

LiviNq
WiTh
YOUR MOTOR HOME
The monitor panel allows you to conveniently check the
approximate levels in the water tanks and to check battery
condition(s).
Electrical probes installed in the tanks measure the levels at
various points in the tanks.
To check tank levels:
Press LP GAS, FRESH WATER, GRAY or BLACK TANK
switches.
The E or empty indicator light will always be lit when the
rocker switches are depressed. If the tank is full, all lights
will be on. Lights are sequential, and indicate level in
approximately V,-tank increments. If the tank selected is
approximately 'I2-full, for example, lights E, '14 and '12 will be
on.
Erroneous tank level indications can be caused by:
a. Water with low mineral content. The level is measured by a
very low level electrical signal traveling through the liquid.
Some water may not conduct the signal properly. This con-
dition may be infrequent, but can exist. Check the panel
reading when the fresh water tank is filled.
b. Material trapped on the sides of the holding tanks may give
a full reading when the tank is actually empty.
To check the battery charge:
1. Unplug the 120-volt AC power cord to turn the power con-
verter olf.
2. Press BATTERY rocker switch on the panel.
3. Turn on a light or any 12-volt appliance. The battery must
be checked with a load.
4. Read battery condition on the meter. Red is low, yellow is
fair and green is good.
MONITOR PANEL
~I
NOTE
If the sensor probes
mounted in the tanks get
coated with grease, the
monitor panel may indi-
cate falsely or not at all.
Avoid pouring grease,
oils or similar substances
down drains or the toilet.
If this is unavoidable, the
holding tank(s) should be
washed out with
a
soapy
water solution. See your
dealer for additional
information.
PACE
Annow
\
te-
l'-