Fleetwood Pace Arrow 2000 Manual page 33

Table of Contents

Advertisement

;p
1:i
:..
~
:;::
~
"
1. Headlight Switch
Wmdshield WiperlWasher (some chassis) on tum signal
stem
2·Speed Windshield WiperlWasher with Delay - Turn knob
clockwise for wiper action.
OFF - No wiper action.
1st notch - Wiper delay ON. Turn outer knob clockwise for
longer delay between wiper strokes.
2nd notch - Slow wiping action.
3rd notch - Fast wiping action.
To WASH - Press inner knob then release. One press of the
washer knob cycles wipers once. The washer nozzles are
located on the wiper arms close to the wiper blades and move
with the blades to provide continuous washer coverage.
2. Auxiliary Start Switch
The Auxiliary Start System allows you to use the coach battery
to start the motor home engine if the chassis battery is dis·
charged.
To use the system, push and hold the button and turn the igni-
tion key to start the engine. Release the button and key switch
when the engine starts.
If both the chassis and coach batteries are dead, the engine
will not crank: Sufficient cranking charge may be restored to
the coach batteries by plugging in to an external 120-volt AC
electrical source or by running the generator.
The Auxiliary Start System has no effect on the vehicle except
to aid in starting the motor home engine. If the vehicle alterna-
tor is operating properly, the batteries will be recharged while
driving (see Electrical System chapter).
Note: If extended normal driving does not recharge the batter-
ies, see an authorized Fleetwood motor home service center.
3. Instrument
Cluster
(Consult
Chassis
Operafor's/Owner's Guide/Manual for details on
instruments. )
4. Generator Hour Meter
5. Cigarette Lighter
6. Generator Start Switch
7. Radio Mode Switch - Switches power to the radio
between the chassis battery and the coach battery.
8. Hood Light Switch
9. S-Witi:lilUliDR [3
available forfoture use)
10. Radio/Cassette Player
11. Cab Heater / AlC Controls - (driverlcockpit area only)
Temperature Control Lever - Adjusts the temperature of the
air coming out of the outlets. Move the lever to the left for cool-
er, and the right for warmer.
Fan Speed Switch - Turns the fan ON and OFF, and adjusts
the fan speed.
Air Intake Button (RECIRC) - Selects the source of the air
being warmed or cooled. When the button is pressed IN
(RECIRC), interior air is recirculated through the system. When
the button is OUT, air from outside the vehicle is drawn through
the system. Normally, set the button OUT to Circulate fresh air
from outside. The RECIRC mode may be used when you
desire faster cooling or heating, or if outside air is unusually
dusty or odorous.
Air Flow Control Buttons - Directs the air to the desired
outlets.
VENT - When this button is pushed, either warmed or cooled
air comes out of the adjustable dash mounted outlets.
BIL - BHeve!. Air comes out of both the dash and floor outlets.
FLOOR - Air comes out of the floor outlets, with some air
directed to the windshield to prevent fogging.
DEF - Air comes out of the windshield outlets to defrost the
windshield. Set the fan switch to HI and the temperature lever
to the far right for maximum defrosting.
Air Conditioning (AlC) ON-OFF Button - Turns air condition-
ing compressor ON and OFF. When air conditioning is desired,
press this button IN and set the fan switch to any position
except OFF.
AlC Indicator Light- This will light when the AlC button is ON.
In the defrost (DEF) mode, the compressor will come on
whether or not the AlC ON-OFF button is on. This helps to
reduce the moisture in the air going to the defroster outlets.
12. Vent Port
Remote Heater Mirror Switch (left side of the instrument
housing) (optional)
Heater Switch - Turns heat ON and OFF at both mirrors.
Mirror Switch - Select right/left mirror and movement of
mirror(s).
~
....
~
==
lit'
~
Q
C:
;l
Q
:ii
I
~
:::z:-
".,
Q
-
: :
~
~
....
lit
-1r
I.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents