Motorola DCP 501 User Manual page 26

1 6 O v e r v i e w
Descriptions of the remote control functions are shown in the following table.
When you press a button on the remote control, a mode button (CATV, DVD/CD,VCR1, VCR2,
Tape, AM/FM, TV, V1 or V2) will turn on to indicate the current mode.
Bu t t o n I t e m
1 SETUP
2 DVD/CD
3 CATV
4 VCR2
5 VCR1
6 PAGE
7 Cursor keys
8 HELP
9 GUIDE
10 LAST
11 VOL
12 MUTE
13 A
14 B
15 NIGHT
16
D C P 5 0 1 U s e r G u i d e
Des c ri p t i o n
Press Once: DCP501 A/V configuration menus.
Select DVD/CD as source. (Remote control remains in tuner mode.)
Select Cable TV as source.
Select VCR 2 as source. Select VCR 2 remote control button codes.
Select VCR 1 as source. Select VCR 1 remote control button codes.
CATV application controlled.
Any DCP501 source: DCP501 display/on-screen display and CATV application
control.
TV source: Move cursor up/down/left/right.
VCR 1 or VCR 2 source: Move cursor up/down/left/right.
Press once: CATV application controlled. (The CATV button does not turn on.)
CATV application controlled.
CATV application controlled.
Raise or lower speaker level.
Any DCP501 source: mute speaker and pre-amplifier outputs.
TV source: mute speaker output .
CATV application controlled.
CATV application controlled.
Press once: DIM mode
DCP501 display dims and audio plays at maximum dynamic range.
Press twice: DIM+SOFT mode
DCP501 display dims and audio plays at minimum dynamic range.
Press three times: DIM+LOUD mode
DCP501 display dims and audio plays at standard dynamic range.
Press four times: NORMAL mode
DCP501 display is not dimmed and audio plays at maximum dynamic
range.
Cable TV source: CATV application controlled.
DVD/CD source:
Press once (in playback): stop playback (resume possible).
Press twice (in playback): stop playback.
Press once (not in playback): open DVD/CD tray.
Press once (tray open): close DVD/CD tray.
VCR 1 or VCR 2 source:
Press once (in playback): stop playback.
Press once (not in playback): eject VHS cassette.