RADIO OPERATION
Select AM Step 9K/10K
In the unit off mode, press and hold the button <AM>
about 5 seconds with the step 9K or 10K appearing in
the display. Press and hold the button <AM> again to
convert between 9K and 10K.
:
05 25
9KStep
Using the Antenna
While listening to the FM or AM programs, please
extend the telescopic antenna fully and get close to the
window to get the best reception. The unit uses an
internal, ferrit bar antenna for AM or LW. While
listening to the AM or LW programs, please rotate the
unit to get the best reception.
Manual Tuning in Stations
1. Turn on the unit and select the band.
2. Adjust the volume.
3. Rotate the knob <TUN.> to your listen to your desired
program.
%
:
%
05 25
10K Step
MONO
FM
Frequency Changes
9
Auto Scan Tuning
1. Turn on the unit and select the band.
2. Press and hold the button <M+> or <M-> with the
frequency changing in the display, then release the
button, the unit is auto scan tuning the stations. When
auto tuning the strong signal, the unit will broadcast the
station.
%
Press and Hold M+or M-
Direct Frequency Entry
Input FM Band Frequency
After inputting FM band number, press the <FM/AM>
button shortly to listen to FM program.
Input AM Band Frequency
First select the frequency range(MW, AM or LW), then
input the frequency number. After inputting the number,
press the <AM> button to confirm.
%
NOTE: While inputting the frequency number, the number "0" at the end
of the frequency can be deleted. The time between two steps is limited,
please perform quickly otherwise the inputting is invalid.
TUNING INTO STATIONS
MONO
:
89 80
VOICE
ALERT
Z
Z
Z
SIREN
FM
NOAA
COUNTY
AIR
FM
ALL
SINGLE
AM
MULTIPLE
WB
ENABLE
PM
DISABLE
Frequency Changes
10
%
%