Power Supply; Ni-Mh Battery / Aa Battery - Kaito KA600 Operation Manual

POWER SUPPLY

Ni-MH Battery
(1)Remove the battery compartment's cover by pushing
the cover in the direction of the arrow.
(2)Install the Ni-MH batteries in its compartment, and
then connect battery port with the unit.
(3)Rotate the <Power Select> to Ni-MH position, the
unit can work normally.
Ni-MH Batteries
Note:The charging function of the unit is only used for the Ni-MH
batteries.
%
SINGLE
<Power Select> Switch
AA Batteries
Compartment
Battery Port
23
AA Batteries
(1)Open the battery compartment's cover.
(2)Install 3 AA size batteries according to the polarity
diagram.
(3)Rotate the <Power Select> switch to "ALKALINE"
position, the unit can work normally.
NOTES:
(1)If you set the <Power Select> to "Ni-MH" position, the unit consume
the Ni-MH batteries, if you set the <Power Select> to "ALKALINE"
position, the unit consume the AA batteries.
(2)Please don't mix the rechargeable batteries with the alkaline ones.
(3)Please don't mix the used batteries with the new ones.
(4)Please don't mix AA batteries with the metal.
(5)If you don' t use the unit for a long period, please remove the AA batteries
lest battery corrosion.
Low Battery Power Warning
When the battery power is low, the <LOW BATT> light
will flash. In this condition, you can't turn on the unit.
If the warning displays, please select the other
charging mode or charge the unit immediately.
POWER SUPPLY
24