Use the Pool Cleaner in the following water conditions only: Chlorine Max 4 ppm 7.0 - 7.8 Temperature 6 – 34°C NaCl Maximum = 5000 ppm Specifications Motor protection: IP 68 Minimum depth: 0.80m Maximum depth: 5m 40°C Max GFI/ELI Set-up K-Bot RX1 | User Instructions...
Page 4
(2) Operation • Turn the power supply ON. The Pool Cleaner will now operate until it has reached the end of the cleaning cycle K-Bot RX1 | User Instructions...
Page 5
• Using the floating cable, bring the Pool Cleaner to the pool's edge. Using the handles remove the Pool Cleaner from the pool. • Do not pull the Pool Cleaner from the pool using the cable. K-Bot RX1 | User Instructions...
Page 6
Maintenance • Place the Pool Cleaner on the edge of the pool and let the water drain out. K-Bot RX1 | User Instructions...
Page 7
Use synthetic cleaning program. • Periodically clean the brushes with a hose. • Refit the filter bag with the tag on the outside positioned centrally along the length side of the bottom lid. K-Bot RX1 | User Instructions...
Page 8
• Place the impeller cover at an angle so that the notch is on the second ring of the spring. Press down on the impeller cover in the direction of the spring, pushing it into place. Replace the screws. K-Bot RX1 | User Instructions...
Page 9
• Thoroughly clean the filter bag and insert in place • Roll up the cable so that it has no kinks • Store the Pool Cleaner in a protected area upside down (not on its brushes) K-Bot RX1 | User Instructions...
Need help?
Do you have a question about the K-Bot RX1 and is the answer not in the manual?
Questions and answers