Advertisement
R
epair
(1) Tools necessary for repair
1. (+) driver
2. (-)driver narrow tip (width about 5mm)
3. Cir-clip pliers (for shaft)
4. Arbor press
5. Resin hammer(or wood hammer)
6. Bar or pipe (diameter:27, length:25 or more)
(this is for making works easier)
(2) Lubricating spots
Apply Makita grease R No.00 or Makita hammer oil XLD (0.5g-1g) for the following places to prevent wear in
early stages and seizure
1. O-ring of impact bolt
2. O-ring of striker
3. Crank joint
O-ring and groove
O-ring and groove
hole inside
outside
Advertisement
